Main frame pin bushing replacement To replace the main frame bushings, proceed as follows: Raise the adjustment ring until the tramp release cylinders are fully EXTENDED. When the ring has been fully raised, place the THREE safety blocks that were furnished with the Crusher at three equally spaced main frame pin locations between the main…
Cone Crusher Main frame pin replacement The main frame pins prevent the adjustment ring from rotating with respect to the main frame and also guide the adjustment ring back to its original position when the ring lifts due to tramp iron or packed material in the crushing cavity. Repeated adjustment ring lift is not normal…
Cone Crusher Seal Replacement The U-shaped seal installed around the gear well portion of the main frame is normally not subjected to contact or wear. However, if the seal is damaged in any way, it is important that it be replaced. The seal prevents oil leakage and protects the precision machined surfaces of the gear,…
Lower Thrust Bearing Replacement What is cone crusher Lower thrust bearing? The cone crusher lower thrust bearing is a component located at the bottom of the cone crusher. It is one of the key parts of the crusher, which supports the entire weight of the crusher during operation. The lower thrust bearing helps to…
What factors affect the capacity of a cone crusher? The cone crusher is one component of the circuit. As such, its performance is in part dependent on the proper selection and operation of feeders, conveyors, screens, supporting structures, electric motors, drive components, and surge bins. Which factors will enhance crusher capacity? Where used, attention to…
Crusher Terminology Introduce As some of our customers do not understand the professional crusher terminology very well, this leads to inconvenient communication. In order that there will be no possibility of confusion or misunderstanding, these terms are defined as to their usage in communication. FEED : The raw material that is to be crushed. LINERS…
Protecting The Cone Crusher Against Rust Corrosion To protect your cone crusher from rust corrosion during the seasonal shutdown, for foreign shipment, or for outdoor storage (winter or summer), the following protective measures are recommended: . Remove the bowl, feed plate, head, socket, and eccentric assemblies. Disconnect the oil drain line at the bottom of…
Cone Crusher Minimum Recommended Spare Parts List The following is a list of the minimum spare parts which should be on hand at all times to insure a minimum of down’ time. Bowl liner. Bowl liner bolts. Mantle. Torch ring. Thrust bearing shims (1 set). It is to be understood that this list contains only…
Cone Crusher General Maintenance Information When performing any maintenance work on the cone crusher, the following general precautions should be observed: When removing parts with machined or bearing surfaces that may rust, they should be well oiled or covered with a rust preventive, if they are to be kept out of the cone crusher for…
Cone Crusher V-belt Initial Installation, Tensioning, and Precautions What is the cone crusher V-belt? A cone crusher V-belt refers to the V-shaped belt that transmits power from the motor to the cone crusher’s main shaft. The V-belt is an important component in the cone crusher because it ensures that the crushing process runs smoothly…
Download Brochure
Product List